Paper jams in the printer, Paper jam in the material feed section, Paper jams in the printer 179 – IBM Oce TDS400 User Manual
Page 179: Paper jam in the material feed section 179
Troubleshooting
179
Paper jams in the printer
Paper jam in the material feed section
If a jam occurs a message appears on the operator panel. If a paper jam occurs,
check if:
■
The roll is loaded correct and the media is fed as indicated.
■
The correct media is used (see ‘List of available material types and sizes’ on
page 214).
■
No scraps of material are blocking the paper path
▼
How to clear a jam in the material feed section
1
Turn off the printer.
2
Open the correct roll compartment.
Note:
One compartment can be open at a time.
3
Lower the feed table, use the two catches on the front underneath the feed table
(see Figure 93).
[93] Lower the feed table
4
Remove the jammed material.
5
Close the feed table.
6
Close the roll compartment.
7
Turn on the printer.
Note:
If you can not clear the paper jam by opening the feed table than open
the fusing section (see ‘Paper jam in the fuser section’ on page 180).