beautypg.com

How to turn on and turn off the océ tds400 printer – IBM Oce TDS400 User Manual

Page 27

background image

Using the Océ TDS400 to Print

27

How to turn on and turn off the Océ
TDS400 printer

To turn on the system:

turn on the printer.

turn on the scanner (see page 53).

turn on the controller(see page 28).

When you turn on the system, it is ready for operation. In this state, the
machine is in the stand-by mode.

If the system is not in use for more than 1 minute, the operator panel returns
automatically to the stand-by mode. The operator panel of the scanner is
activated in the following conditions:

you feed an original

a key on the operator panel is pressed

Turn on the printer

1

Set the ON/OFF switch at the rear of the printer to position ‘1’ (see Figure 6).
If the power supply is connected, the green switch lights.

[6] On/off switch of the printer

Note:

When ‘Ready’ is displayed on the operator panel, the printer is ready for

use.