IBM Oce TDS400 - Manual (Page 61)

Using the Océ TDS400 to Copy 61
▼ To enable automatic feed
1 Press the Extra key.
2 Select ‘Scanner’ with the or key.
3 Press the key, to enter the ‘Scanner’ menu.
4 Select ‘Autofeed orig.’ with the or key.
5 Press the key, to enter the ‘Autofeed orig.’ menu.
6 Select ‘on’ or ‘off’ with the or key.
7 Press the ‘confirm’ key.
Define settings for the next original
For each original you need to copy you can specify new settings.
▼ Define settings for the next copy job
1 Select all the needed settings for the next original.
2 Insert the next original.
Copy on pre-cut sheets
If you copy a job on a media type and/or size that is not available on one of the
paper rolls, you can manually feed sheets instead of reloading paper rolls. You
can insert pre-cut copy material in this slot, one sheet at a time. To set the time
out for manual feed refer to ‘Set the time-out for manual feed’ on page 63.
▼ Copy on pre-cut sheets
1 Enter the type of the copy material on the printer operator panel.
2 Press the ‘media’ key on the scanner panel to select ‘manual feed’. The
indicator lights up.
Note: The minimum length of the print material must be 420 mm.