beautypg.com

The display, The display 50 – IBM Oce TDS400 User Manual

Page 50

background image

50

Océ TDS400 User Manual

The display

The display shows the feedback about the scan job status (see table below) in
normal mode. In off-line mode it shows the off-line menu (see page 71) and
(see page 82))

.

Status messages

Status Messages

Explanation

Scanner ready

The scanner is prepared to scan.

+

= add
= close

Add an original to the set and press the Start key

.

After the last scan of the set, remove the original and press
the Start key

to close the set

.

Connecting.....

There is no communication between the controller and the
scanner.
Wait until the there is communication.

Scanner asleep

The scanner is in low power mode.

Scanner running

The scanner scans.

Please wait

The scanner downloads the languages.

Remove original
Press

There is an original on the table while you turn on the scan-
ner.
The message appears if you pressed the Cancel key while
you scan.
Remove the original.
Press cancel.

Original too long
Press

Use an original shorter than 15 meter.

Wrong orig. type
Press

This message shows when you select ‘Background compen-
sation’ and ‘Blueprint’ as original.
Press cancel.

Set closed

You closed the copy set.

Reset scanner

Turn the scanner on and off.