beautypg.com

IBM Oce TDS400 User Manual

Page 192

background image

192

Océ TDS400 User Manual

[116] Opening the guide plates

3

Remove all tape between the rollers and knives (see Figure 117).

[117] Removing the tape

4

Lead a new trailing strip of tape between the rollers and knives.

No reinforcement strips on the output without an error message

Solve this error

1

Put the printer off-line by pressing the On-line key on the operator panel.

2

Open the side door of the reinforcement unit.

3

Check if there are loose reinforcement strips in the unit with the protection
sheet still on (see situation B in figure 118).