IBM Oce TDS400 - Manual (Page 28)

28 Océ TDS400 User Manual
▼ Turn off the printer
1 Set the ON/OFF switch at the rear of the printer to position ‘0’ (see Figure 4).
Attention: If you switch off the printer during a print job, it is possible that
you lose information or that a paper jam occurs.
▼ Turn on the controller
1 Press the key on the front of the controller.
▼ Turn off the controller
1 Select the ‘Shut down’ option from the Océ System Control Panel. You can do
this through both the controller and through Océ Remote Logic®.
2 Switch off the controller and the monitor.
Cancel a print
Cancel a print before you start the print or during the print.
▼ Cancel a print
1 Press the Stop key.
The printer stops.
When the printer runs, the paper is cut.
The paper is always ejected.