beautypg.com

IBM Oce TDS400 User Manual

Page 167

background image

Printer Supplies and Maintenance

167

[78] Leading the tape between upper and lower knife

4

Make certain that at least 200 mm (2 strip lengths) of tape protrude from the
knife section (see Figure 79).

[79] Protruding tape

5

The holes in the tape must be aligned with the hole pattern on the sticker you
can find on the frame plate of the reinforcement unit (see Figure 80). If this is
not the case, you lift the tape from the pin roller and push the tape further
between the two knives until the holes are aligned.