IBM Oce TDS400 User Manual
Page 43
Using the Océ TDS400 to Print
43
Sensor not free
Remove paper
Press
The paper of one of the rolls is transferred after the marker (see
‘Feed the material’ on page 155) when power is applied to the
printer.
Take the paper back.
Press
Paper retracted
Press
Put the paper into the manual feed.
Press
Copy too short
Remove paper
Press
The length of the print material is less than 420 mm. This can oc-
cur with the manual feed.
Use an original longer than 420 mm.
Inputflap open
Close inputflap
The input flap is open.
Close the input flap.
Inputflap open
Remove paper
Press
The input flap is open during the print process
Remove the paper and press
Roll 1 empty
Open roll unit
The paper on roll 1 is empty.
Open the roll unit and replace it.
Roll 2 empty
Open roll unit
The paper on roll 2 is empty.
Open the roll unit and replace it.
Wait for folder
The communication between the printer and the folder starts up.
Folder is off
The communication between the printer and the folder was not es-
tablished.
Folder belt full
The belt of the folder is full.
Empty the belt of the folder.
RU tape empty
The tape roll of the reinforcement unit is empty.
Open the reinforcement unit and replace the empty tape roll.
Status Messages (continued)
Status messages Explanation