Get hw fibre channel port selection, Set control state, 4 get hw fibre channel port selection – Intel NetStructure MPCBL0001 User Manual
Page 50: 5 set control state
50
Technical Product Specification
Order #273817
Intel NetStructure
®
MPCBL0001 High Performance Single Board Computer
Contents
3.7.4
Get HW Fibre Channel Port Selection
This command returns the current Fibre Channel port routing selection as set in the hardware. The
command is available over KCS and IPMB interface SetFiberChannelPortSelection.
3.7.5
Set Control State
This command sets the state of a control pin and overrides the control pin’s auto state. Refer to
on
for control number information.
Table 15.
Get Fibre Channel Port Selection
7
6
5
4
3
2
1
0
NetFn/LUN
NetFn = 3Ah (OEM Request)
RsLUN
Command
Cmd = 03h
Byte 1
Intel IANA number (LSB) = 57h
Byte 2
Intel IANA number = 01h
Byte 3
Intel IANA number (MSB) = 00h
Byte 1
Completion code
Byte 2
Intel IANA number (LSB) = 57h
Byte 3
Intel IANA number = 01h
Byte 4
Intel IANA number (MSB) = 00h
Byte 5
Fibre Channel 1 setting, 0=disabled, 1= Front panel, 2= Backplane, 3= reserved.
Byte 6
Fibre Channel 2setting, 0=disabled, 1= Front panel, 2= Backplane, 3= reserved.
Table 16.
Get HW Fibre Channel Port Selection
7
6
5
4
3
2
1
0
NetFn/LUN
NetFn = 3Ah (OEM Request)
RsLUN
Command
Cmd = 04h
Byte 1
Intel IANA number (LSB) = 57h
Byte 2
Intel IANA number = 01h
Byte 3
Intel IANA number (MSB) = 00h
Byte 1
Completion code
Byte 2
Intel IANA number (LSB) = 57h
Byte 3
Intel IANA number = 01h
Byte 4
Intel IANA number (MSB) = 00h
Byte 5
Fibre Channel 1 Settings, 1 = Front Panel, 2 = Backplane
Byte 6
Fibre Channel 2 Settings, 1 = Front Panel, 2 = Backplane