Configuring a static route for the ppp console, Hardware requirements for routing, Hardware requirements for routing - 36 – Motorola CAJUN P880 User Manual
Page 70
2 - 36
Cajun P880 Routing Switch Installation Guide
2
7. In the Mask field, enter the network mask IP address (for
example, 255.255.255.0).
8. Click APPLY to save your changes, or CANCEL to restore
previous settings.
Configuring a Static
Route for the PPP
Console
To configure a PPP Console static route:
1. Configure your console serial port as a PPP Console. Refer to
"Connecting a Modem", earlier in this chapter.
2. From the IP Configuration section of the Web Agent window,
click
Static Routes. The IP Static Routes dialog box opens.
3. Click CREATE. The Add IP Static Routes dialog box opens. This
allows you to define a static route for the PPP console.
4. In the Network Address field, enter the IP address to be
associated with the PPP console port.
5. In the Mask field, enter the network mask IP address.
6. In the Next-Hop Address field, enter the IP address of the
gateway associated with this static route.
7. Click APPLY to save your changes, or CANCEL to restore
previous settings.
Hardware Requirements for Routing
To configure your switch as an IP/IPX or AppleTalk router, you must
first configure your Cajun switch with the following hardware:
■
P880 supervisor module (mandatory)
■
Layer 3 media modules (optional) including:
—
2-Port Gigabit Ethernet module
—
10-Port 100-BASE-F module
—
12-Port 10/100-BASE-T module