Motorola CAJUN P880 - Manual (Page 67)

Cajun P880 Routing Switch Installation Guide 2 - 33
Regaining
Configuration
Access to the PPP
Serial Port Console If the PPP serial port console is configured incorrectly, the command
line interface (CLI) becomes temporarily unavailable for
reconfiguration.
To regain access to the CLI when the console port is in PPP mode:
1. In the console window, type TTY. The CLI login prompt displays.
It may be necessary to press Enter several times to see the login
prompt. You may see the modem init command string.
2. At the Login prompt, enter your user name. The password
prompt displays.
3. At the Password prompt, enter your password. The Cajun CLI
prompt displays.
4. Enter the PPP configuration commands necessary to start PPP.
Refer to “Configuring the Serial Console Port as a PPP Console”,
earlier in this chapter, and “Creating an IP Interface”, in Chapter
7, for more information on PPP configuration commands.
5. After you complete your configuration settings, type exit at the
CLI prompt to reinvoke the modem control software and exit
CLI mode.
* Note: You do not need to exit from CLI if the serial
port console has been configured as a TTY
console, or if you do not intend to re-attempt
connecting using PPP.
Configuring Dial-Up
Networking To configure your PC for dial-up networking with a PPP serial port
console:
1. From My Computer, double-click Dial-Up Networking. The
Dial-Up Networking dialog box opens.
* Note: You must have dial-up networking installed on
your PC.
2. Double-click Make New Connection to configure your
modem. The Make New Connection wizard opens.
3. In the Type a name for the computer you are dialing field,
enter a connection name for the computer you are dialing.
4. From the Select a Modem pull-down menu, select your
modem and click Configure. The Modem Properties dialog box
opens.
5. Click the Connection tab. The Connection tab opens.