Motorola CAJUN P880 User Manual
Page 66
2 - 32
Cajun P880 Routing Switch Installation Guide
2
To configure the console serial port as a PPP console:
1. In the System Configuration section of the Web Agent
window, select
Console Configuration. The Console
Configuration dialog box opens.
2. Click PPP for your console type and click Select. The Console
Port Configuration dialog box opens.
3. Use Table22 to change your console port settings.
* Note: The only parameters you can change as a PPP console is
baud rate and flow control. The flow control settings are
limited to None or Xon/Xoff.
4. In the Modem Init Cmd field, enter your modem
initialization command. The default modem configuration
string is
AT&D0S0=1.
5. Click APPLY to save your changes, or CANCEL to restore
previous settings.
* Note: If you misconfigure your PPP serial console port, you can
regain CLI access to correct the configuration
parameters. For more information, refer to “Regaining
Configuration Access to the PPP Serial Port Console”.
Safety Tip: To successfully dial-in with PPP to the switch, you must
also configure an IP address and interface for the PPP Serial Interface
(Serial-Console).
Table 23. Modem Configuration String Parameters
Parameter
Definition
&D0
Disable DTR
S0=1
Auto-answer mode (one ring)
CD follows carrier
Depends on modem
E0
Disable local echo
Software Flow Control
(Receive and Transmit)
Depends on modem