Using the all ports configuration dialog box, Using the all ports configuration dialog box - 16 – Motorola CAJUN P880 User Manual
Page 50
2 - 16
Cajun P880 Routing Switch Installation Guide
2
Using the All Ports Configuration Dialog Box
The All Ports Configuration dialog box allows you to apply the same
parameter settings to all ports in a module using a single command.
To set all ports in a module:
1. In the System Configuration section of the Web Agent
window, select
Modules & Ports. The Module Information
dialog box opens.
2. In the Ports column, click the number for the module you want
to configure (for example,
10 for 100BASE-FX). The Port
Configuration dialog box opens.
3. Click All Module Switch Ports Configuration. The All Ports
Configuration dialog box opens.
4. Set port parameters as described beginning in “Configuring
Physical Port Parameters on Gigabit Ports”, earlier in this chapter.
5. Click APPLY to save your changes, or CANCEL to restore
previous settings.
Rate Limit
Burst Size
Determines the limit of packets allowed in a
single burst. Accepted values are 1 to 2048. For
Fast Ethernet ports, set this value lower than
1024 (output buffer capacity). Lower this value
if the port has overflow problems.
Port PACE
Priority
Determines if the port detects 3Com’s
proprietary PACE format as packets pass
through the port. PACE allows a packet’s
priority (higher priority packets move through
the switch before lower priority packets) to be
set at the adapter.
Table 10. Fast Ethernet (10/100) Port Parameters
Parameter
Definition