Motorola CAJUN P880 - Manual (Page 31)

Cajun P880 Routing Switch Installation Guide 1 - 21
Installing/Removing Switch Controllers/Elements
The following sections explain how to install switch controllers and
elements.
Installing Redundant Controllers/Elements
By default, the switch is configured without the redundant
controller or element.
CAUTION
Before replacing switch controllers or elements, turn off the
Cajun P880 Switch.
To install the redundant modules and enable module redundancy:
1. Turn power off and unplug the Cajun P880 Switch.
2. Using a Phillips-head screwdriver, loosen the captive screws on
the rear panel.
3. Carefully pull the rear panel away from the chassis.
4. Carefully remove the Switch Element or Switch Controller card
from the shipping box.
5. In order to take appropriate antistatic precautions, plug your
ESD strap/device into the jack (this takes a standard banana
jack) on the chassis (Figure 12), and carefully remove the card
from the antistatic wrap.
* Note: The ESD jack is only available when the rear
panel has been removed.