Motorola CAJUN P880 - Manual (Page 58)

2 - 24 Cajun P880 Routing Switch Installation Guide
2
8. Use Table15 to configure your switch VTP Snooping parameters.
9. Click APPLY to save your changes, or CANCEL to restore
previous settings.
Configuring Non-VLAN Switch Port Parameters
To configure Non-VLAN switch port parameters:
1. In the Switch Port Configuration dialog box, from the Allow
Learning pull-down menu, select Disable to stop the port’s
learning of new addresses. This feature can be useful for security.
Selecting Enable allows the port to learn new addresses.
For example, you can set this parameter to Disable, then add a
static MAC address entry for this port.
2. From the Hunt Group pull-down menu, select a hunt group
for which this port will be a member. Refer to “Using Hunt
Groups to Aggregate Bandwidth between Switches”, in
the Cajun
P550/P220 Switch Operation Guide , for more information on hunt
groups.
Table 15. VTP Snooping Parameters
Parameter Definition
VTP Snooping
State Select to enable or disable the VTP snooping
protocol globally for the switch. The default value
is Disabled.
Domain
Name Enter the name associated with the Cisco VTP
domain. The default is Null.
Note: The domain name is automatically
learned within approximately five
minutes from a Cisco VTP switch provided
both the Domain Name is Null and the
VTP Snooping State is enabled on the
Cajun switch.
Configuration
Revision
Number Displays the VTP snooping configuration revision
number associated with the last successful VTP
configuration update on the Cajun switch.
Updater
Identity Displays the IP address of the Cisco switch that
initiated the configuration update.
Update
Timestamp Displays the date and time that the Cisco switch
initiated the configuration update.