Setting up snmp communities, Setting up snmp communities - 28 – Motorola CAJUN P880 User Manual
Page 62
2 - 28
Cajun P880 Routing Switch Installation Guide
2
5. Set port parameters for the selected ports, as described in
“Viewing Switch Port Parameters”, earlier in this chapter.
6. Click APPLY to save your changes, or CANCEL to restore
previous settings.
Setting Up SNMP Communities
SNMP communities are the SNMP values that an SNMP manager
uses to manage the switch. SNMP Version 2c is supported.
To set SNMP communities:
1. In the System Configuration section of the Web Agent
window, select
SNMP Administration. The SNMP Community
Management dialog box opens.
2. Click CREATE. The Create SNMP Community dialog box opens.
3. In the Community String field, enter a community name.
4. From the IP Address pull-down menu, select Any for any IP
address or
Specific and enter an IP Address in the appropriate
fields.
Table 19. SNMP Communities Parameters
Parameter
Definition
Community
String
This string serves as a password that you enter at
the network management station. It provides the
level of access to the switch that you specify on
this page.
IP Address
Allows you
to send SNMP responses only to a
station with any or a particular IP address.
Access
Helps provide security when you use SNMP to
manage the network from a single workstation.
Refer to Table20 for more information on Access
options. The default is Read-Write.
Security
Level
Allows you to select the security level for this
community string. Refer to Table21 for more
information on security level options. The default
is Normal.
Trap
Receiver
Allows you to enable or disable the transmission
of traps to the selected IP address. The default is
Disable.