Motorola CAJUN P880 - Manual (Page 15)

Cajun P880 Routing Switch Installation Guide 1 - 5
2. Lay out the static-dissipative work surface.
3. Connect the ground cord assembly to the ESD mat and to the
ground plug on the front fan tray. This takes a standard banana
jack or a #10-32 screw.
4. Wear the ESD wrist strap and attach it to the ground cord
assembly.
Installing the Mounting Shelf
* Note: The screws and nuts needed to attach the shelf to the
rack are not supplied. It is recommended you use, at
least, a quantity of three #10 pan head screws for
installation.
There are three brackets supplied for the shelf installation: shelf
pieces and one brace for the rear of the rack. To install the shelf:
1. Install the mounting shelf. Attach the two side shelf pieces to the
rack. Make sure that each hole on the mounting bracket lines up
with a hole on the rail. This ensures proper vertical placement in
the rack. Do
not completely tighten the screws.
2. Attach the brace piece to the shelf pieces by inserting the
attached stud into the holes on the shelf pieces and tightening
the nuts (Figure 2).
3. Check the rack and shelf to ensure they are square before
installing the chassis. Tighten all screws before installing the
chassis.
Figure 2. Installing the Mounting Shelf