Changing the console serial port settings, Changing the console serial port settings - 30 – Motorola CAJUN P880 User Manual
Page 64
2 - 30
Cajun P880 Routing Switch Installation Guide
2
Changing the Console Serial Port Settings
You can use the Web Agent to change the communications settings
for the serial port connection on the front panel of the Layer 3
supervisor module.
Initially, the switch’s console port is configured as a TTY Console to
support a TTY connection. The Layer 2 and Layer 3 supervisor
modules allow you to reconfigure the console serial port as a PPP
Console to support a dial-in PPP connection using a modem.
* Note: As a PPP console, you can change only the switch’s baud
rate and flow control parameters. The flow control
parameters are limited to None or Xon/Xoff.
Configuring the
Serial Console Port
as a TTY Console
To configure the console serial port as a TTY Console:
1. In the System Configuration section of the Web Agent
window, select
Console Configuration. The Console
Configuration dialog box opens.
2. Click TTY for your console type and click SELECT. The Console
Port Configuration dialog box opens.
3. Use Table22 to set your console serial port settings:
4. Click APPLY to save your changes, or CANCEL to restore
previous settings.
Table 22. Console Serial Port Options
Option
Default
Available Settings
Baud
Rate
9600
300, 1200, 2400, 4800, 9600, 19200,
38400, 57600, 115200
Flow
Control
Xon/Xoff
(TTY)
None, Xon/Xoff (TTY)
Data
Bits
8
7 or 8
Parity
None
Odd, Even, or None
Stop
Bits
1
1 or 2