Motorola CAJUN P880 - Manual (Page 21)

Cajun P880 Routing Switch Installation Guide 1 - 11
Removing a Power Supply
To remove a power supply:
1. Make sure that the ON/OFF switch on the power supply is OFF
(O) and the power cord removed.
2. Unfasten the captive screw securing the power supply.
3. Grasp the power supply in the finger pull (Figure 5) on the front
and pull straight out of the chassis.
4. Slowly remove the supply from the chassis.
WARNING
Support the bottom of the power supply with your free
hand.
Removing a Power Supply Filler Panel
To remove a filler panel:
1. Unfasten the captive screw securing the filler panel.
2. Grasp the filler panel at the bottom and pull up and forward.
Make sure all open slots have a filler panel to maintain EMI/FCC
integrity (Figure 6).
WARNING
Support the bottom of the power supply with your free
hand.
3. Remove the filler panel from the chassis.