Terminal settings, Configuring the supervisor module using the cli – Motorola CAJUN P880 User Manual
Page 37
Cajun P880 Routing Switch Installation Guide
2 - 3
Terminal Settings
To complete initial switch setup, you need a PC with a serial line
connection. It must have the following terminal settings to
communicate with the switch (Table 7).
Configuring the Supervisor Module Using the CLI
To connect to the Web Agent, you must first use the serial command
line interface (CLI) to give the supervisor module an IP address and
a subnetwork mask. To configure the supervisor module using the
CLI:
1. Attach a serial cable from your PC’s serial port to the serial port
of the supervisor module front panel (refer to Figure 13.) using a
9-pin straight-through male-to-female serial cable (refer to
“Switch Features,” earlier in this guide for pinout information).
2. Run a terminal emulation program (HyperTerminal, for
example) on the attached PC. Ensure that the terminal settings
match those listed in Table 7.
3. Power up the switch by turning on the power supplies. In the
terminal emulation program, the switch displays the following
startup messages:
Booting the operational system, please wait ....
Initializing the event subsystem ... done
Initializing the agent subsystem ... done
Initializing the platform ...
Resetting Thunderbolt ...done.
Setting module to MASTER and resetting chips ...done.
Creating Ethernet Console ...done.
Creating Display Manager ...done.
done
Initializing the switch subsystem ... done
Starting up threads ...
Periodic Task
Event
Network Interface
Switch Interface
Module Manager
Table 7. Terminal Settings
Baud
Rate
Stop Bits
Data Bits
Flow
Control
Parity
9,600
1
8
Xon/Xoff
None