beautypg.com

Configuring the ip interface for the ppp console – Motorola CAJUN P880 User Manual

Page 69

background image

Cajun P880 Routing Switch Installation Guide

2 - 35

Using Dial-Up
Networking with a
PPP Serial Port
Console

To use TCP/IP applications (Telnet, HTTP, and SNMP) over your PPP
serial port interface:

1. From My Computer, double-click Dial-Up Networking. The

Dial-Up Networking program group opens.

2. Double-click on the PPP modem previously created. The

Connect To dialog box opens.

3. Enter your password and click Connect. A Pre-Dial Terminal

Screen opens.

When the modem has successfully connected, a Post-Dial
Terminal Screen opens.

4. In the Post-Dial Terminal screen, login using your CLI user

name and password. It may be necessary to enter several
carriage returns to view the Login prompt.

5. At the CLI prompt, go to configuration mode and enter set

console transfer PPP. ASCII characters display below the CLI
prompt. This is typical while the switch attempts to connect via
PPP.

6. In the Post-Dial Terminal screen, click Continue (F7). PPP

verification completes and the Connected To dialog box displays
a message that the modem connection has been successfully
established.

Configuring the IP
Interface for the PPP
Console

To configure the PPP console with an IP address and mask:

1. Configure your console serial port as a PPP Console. See

“Connecting a Modem”, earlier in this chapter.

2. Connect your modem cable to the Cajun’s serial port.

3. From the IP Configuration section of the Web Agent, click

Interfaces. The IP Interfaces dialog box opens.

4. Click CREATE. The Add IP Interface dialog box opens.

5. From the VLAN pull-down menu, select Serial-Console. This

specifies the interface for the PPP console.

6. In the Network Address field, enter the IP address to be

associated with the PPP console port.

* Note: If you do not enter a name for this interface, the

IP address is used as the interface name.