2 connecting the fp0, 1 connecting to the com.port, Connecting to the com. port – Motorola GT10 User Manual
Page 68: 1 connecting to the com. port, Fp0 communication format settings, Connecting to the fp0 com. port
GT10/GT30
4.2 Connecting the FP0
45
4.2
Connecting the FP0
4.2.1
Connecting to the COM. Port
FP0 communication format settings
GT30
Loose–wire connection
FP0 COM. port
GT10
System register no. Item
Value Set
System register value
412
Selection of target
use of RS232C port
Computer link
K1
413
Data length
8 bits
K3
Parity check
Yes
Parity setting
Odd
Stop bits
1 bit
Line return code
CR
Start code
No STX
414
Baud rate setting
19200 bits/s
H0 * 00
415
Unit number
1
K1
416
Modem connection
No connection H0
Connecting to the FP0 COM. port
GT10/GT30
FP0
S
SD
R
RD
G
SG
PLC side
Pin no.
Abbreviation
SD
SD
RD
RD
RS
RS
CS
CS
GND
GND
GT main unit side
Pin no.
Abbreviation
CAUTION
Because loose wiring is used for connection to the FP0 COM. port, no
dedicated cable is available. The cable should be provided by the
←To set 19200 bits/s
for both the COM.
port and the TOOL
port, “H0100”
should be set.