Motorola GT10 - Manual (Page 119)

GT10/GT30 6.2 Entering Configuration Settings with GTWIN
96
“Basic Setup” screen
Title ––– The title of the configuration settings file is entered here. Titles are convenient
if each GT30 has its own configuration settings.
PLC Model ––– The model of PLC specified when GTWIN is booted is displayed here.
GT Model ––– The model of GT specified when GTWIN is booted is displayed here.
Basic communication area to PLC
The following explains how to specify a device in the PLC to be used for basic
communication between the GT30 and the PLC.
Device used
This specifies the internal PLC device used for basic communication between the GT30
and PLC.
·
Word area ––– This specifies the type of device that reads and writes screen
numbers and other information in word units, and the initial address.
·
Bit area ––– This specifies the type of device that reads and writes backlight
control and other bit information, and the initial address.
The type of device and addresses can be set by clicking on the buttons for the
various items.