Motorola GT10 - Manual (Page 125)

GT10/GT30 6.2 Entering Configuration Settings with GTWIN
102
in the initial address of the word device under “Basic
Communication Area to PLC” in the “Basic Setup” parameters
under “GT Configuration” will be displayed.
This function is used when it is necessary to delay the start–up time
when the power supply on the PLC side is turned on.
CAUTION
Communication between the GT30 and the PLC (external device)
cannot be carried out during the time specified by the “Display
Time” parameter.
6.2.6 GT Configuration Settings: “Setup”
Clicking on the “Setup” tab in the “GT Configuration” dialog box displays the screen
shown below. Here, clock functions, backlight control, and other parameters can be
specified.
“Setup” screen
Clock
Clock
This is used to specify the reference destination for the clock displayed with the GT30.
Select one of the radio buttons.
GT Clock ––– When the time is displayed, the internal clock in the GT30 is used as a
reference for the value.
PLC Clock ––– When the time is displayed, the internal clock in the PLC is used as a
reference for the value.
If the “PLC Clock” is referenced for the clock setting, clicking on the button displays
a screen where the type of device and the address can be specified.