Motorola GT10 - Manual (Page 53)

GT10/GT30 3.2 Setting the Basic Communication Area, GT10 and PLC
30
shown below.
Clicking on the
button in “Basic Communication Area to PLC” displays the device
settings dialog box shown below, where the initial addresses for the word area and bit
area can be changed.
GT10 Configuration Basic Setup dialog box
EXPLANATION
Key operation in the Device Settings dialog box
Click on the
button to display a pull–down menu, and then select
the device for which settings are to be entered. Use the ten–keys to
enter the address.
The
button acts as a backspace key when entering an
address, and the button functions as a Clear key.
3.2.2 GT10 Basic Communication Area Map
In order for communication to be carried out between the GT10 and PLC, an internal
device area like that shown below is provided in the PLC. This should be used to control
the GT main unit through the PLC ladder program actually being run.
The starting address “N” of the field shown below is specified in the GT10 configuration
settings of GTWIN screen creation tool, and is then sent to the GT main unit.