Gateway ALR 8300 - Manual (Page 39)

Installing Components 27
3. Wearing an anti-static wristband grounded to the system chassis,
remove the lock bar from the processor support. See Figure 9.
Figure 9: Removing the Lock Bar
4. Remove the two screws that secure the processor cartridge in the
supports and remove the lock bar.
5. Lift the processor cartridge straight up and away from the system
board. See Figure 10.
Figure 10: Removing the Processor Cartridge
Important!
If the error message
“update table not found for
CPUxx, Stepping xxxx”
displays at boot up, run the
MULOADER utility located
on the disk included with
your processor kit. This
message may occur under
the following conditions:
When a new processor has
been added that does not
include the stepping
information in the table.
When the BIOS is flashed,
it may remove the stepping
information form the table
which will cause the error
message to appear.
4081TL.book Page 27 Tuesday, December 22, 1998 1:27 PM