Gateway ALR 8300 - Manual (Page 19)

System Access 7
Closing the system
Before closing the system, verify that all connectors and boards are
properly installed and firmly seated.
Reinstalling the bezel
You must replace the bezel before you replace the wrap-around panel and
the side panel.
1. Position the bezel to the front of the chassis so that the bezel pegs are
aligned with the mounting holes on the front of the chassis. See
Figure 4.
Figure 4: Reinstalling the Bezel
To Replace the Bezel
4081TL.book Page 7 Tuesday, December 22, 1998 1:27 PM