beautypg.com

1 cable routing, 5 connecting the system unit to the mains, Cable routing – FUJITSU BX900 S1 User Manual

Page 52: Connecting the system unit to the mains, Section "connecting the system unit, Section "connecting the, 52 operating manual, Installing the hardware, Caution

background image

52

Operating Manual

BX900 S1

Installing the hardware

©

c

o

gn

itas

. G

es

el

ls

ch

ft f

ür

T

ec

h

ni

k-

Do

ku

m

en

tat

io

n

m

bH

2

01

1

P

fa

d:

C

:\P

rogr

am

m

e

\F

CT

\t

im

_ap

p\

tim

_l

oc

al

\w

ork

\W

A

LT

E

R

\O

B

J_

DO

K

U

-4

94

9-0

07

.fm

I

The service LAN port (pos. 1 in

figure 8 on page 51

) and the LAN ports

for blade server management (pos. 4 and 5 in

figure 8 on page 51

) must

be in different LAN subnetworks.

It is recommended to operate the management blade user interface in a
separate broadcast domain for the server management.

Ê

Connect the data cables according to the system configuration you require.

Ports on the back of the system unit

On the front of the system unit are the ports of the server blades for local
administration. For information on these, see the operating manuals for the
relevant server blades.

4.4.1

Cable routing

The cables are routed along the support uprights of the rack.

4.5

Connecting the system unit to the mains

The system unit has six bays for hot-swap power supply units. In the base
configuration, it is fitted with three power supply units.

V

CAUTION!

Read the information on determining how many power supply units
are required (see

"Hot-plug power supply units" on page 127

).

The power supply units automatically adjust to a mains voltage
between 100 - 240 V. The system unit may only be used if the local
mains voltage is within the voltage range of the system.

The 2880 W power supply units may only be connected to 16 A
power outlets, a UPS, a 32 A power distribution unit, or CEE sockets.
When ordering the system unit, you must specify which socket type
is available at the installation location, so that the cables with the
appropriate C19 connectors can be supplied.

For the Japanese market:
The 918W power supply units may only be connected to NEMA L6-
30, IEC 60320-C20, or NEMA 5-15 sockets.