FUJITSU BX900 S1 - Manual (Page 15)

BX900 S1 Operating Manual 15
Introduction
To use connection blade stacking, the firmware version of the
management blade of the BX900 S1 system unit must be at least
V4.27.
I
This connection blade can be used in all connection blade slots.
Ethernet connection blades in slots CB3/4 (fabric 2), CB5/6 (fabric
3) and CB7/8 (fabric 4) only support server blades that are fitted
with an Ethernet mezzanine card.
– Connection Blade GbE Switch/IBP 18/6 (SB6)
– 18 internal 1-Gbit ports to the server blades
– 6 external 1-Gbit ports through RJ45 connections
I
This connection blade can be used in all connection blade slots.
Ethernet connection blades in slots CB3/4 (fabric 2), CB5/6 (fabric
3) and CB7/8 (fabric 4) only support server blades that are fitted
with an Ethernet mezzanine card.
– Connection Blade 10 GbE Switch/IBP 18/8
– 18 internal 10-Gbit ports to the server blades
– 8 external 10-Gbit ports through SFP+ modules or active twinax
cables (copper)
I
This connection blade can be used in slots CB1/2 (fabric 1),
CB3/4 (fabric 2) and CB5/6 (fabric 3).
10 GbE connection blades in slots CB3/4 (fabric 2) and CB5/6
(fabric 3) only support server blades that are fitted with a 10 Gbit
Ethernet mezzanine card or with a 10 Gbit CNA mezzanine card.
– Connection Blade Ethernet Pass Thru 10Gb 18/18
– 18 internal 1/10-Gbit ports to the server blades
– 18 external 1/10-Gbit ports through SFP/SFP+ modules
I
This connection blade can be used in slots CB1/2 (fabric 1),
CB3/4 (fabric 2) and CB5/6 (fabric 3).
10 GbE connection blades in slots CB3/4 (fabric 2) and CB5/6
(fabric 3) only support server blades that are fitted with a 10 Gbit
Ethernet mezzanine card or with a 10 Gbit CNA mezzanine card.
●
Fiber Channel connection blades
– Connection Blade 8Gb FC Switch 18/8