FUJITSU BX900 S1 - Manual (Page 28)

28 Operating Manual BX900 S1
Important notes
©
c
o gn
itas
. G
es
el
ls
ch
ft f
ür
T
ec
h
ni
k-
Do
ku
m
en
tat
io
n
m
bH
2
01
1
P
fa
d:
C
:\P
rogr
am
m
e \F
CT
\t im
_ap
p\
tim
_l
oc
al
\w
ork
\W
A
LT
E
R
\O
B
J_
DO
K U
-4
94
8-0
07
.fm
Before starting up
V
CAUTION!
●
During installation and before operating the device, observe the
instructions on environmental conditions for your device (see
"Ambient conditions" on page 23 ).
●
If the server has been moved from a cold environment, condensation
may form both inside and on the outside of the machine.
Wait until the server has acclimatized to room temperature and is
absolutely dry before starting it up. Material damage may be caused
to the server if this requirement is not met.
●
Only transport the server in the original packaging or in packaging
that protects it from impacts and jolts.
For the Japanese market, transporting the device in its original
packaging does not apply.
Installation and operation
V
CAUTION!
●
The device may only be operated in a maximum ambient temperature
of 35 °C.
●
If the device is integrated in an installation that receives power from
an industrial (public) power supply network with the IEC309
connector, the (public) power supply protection must comply with the
requirements for the non-industrial (public) power supply networks for
the type B connector.
●
The device automatically adjusts to a mains voltage in the range of
100 - 240 V. Make sure that the local mains voltage is neither above
nor below these limits.
●
This device must only be connected to properly grounded power
outlets or to the insulated sockets of the rack's internal power supply
using safety-tested power cables.
●
Make sure that the device is connected to a protective contact socket
that is close by the device.