Selecting an input source – Fostex PD-6 User Manual
Page 61
59
PD-6
DVD Location Recorder (Chapter 5: Recording/playback)
“L” position
“D” position
“P” position
“T” position
Mic input
Line input
[INPUT SEL] select switches
[PHASE] switches
[INPUT GAIN] controls
44.1kHz/16bit-2TR
118
48kHz/16bit-2TR
108
59
44.1kHz/16bit-4TR
48kHz/16bit-4TR
54
47
44.1kHz/16bit-5TR
48kHz/16bit-5TR
43
44.1kHz/16bit-6TR
39
44.1kHz/24bit-2TR
78
48kHz/24bit-2TR
72
39
44.1kHz/24bit-4TR
48kHz/24bit-4TR
36
31
44.1kHz/24bit-5TR
48kHz/24bit-5TR
28
44.1kHz/24bit-6TR
26
88.2kHz/24bit-2TR
39
96kHz/24bit-2TR
36
48kHz/16bit-6TR
36
48kHz/24bit-6TR
24
You can make recording on both sides A and B of an 8-centimeter DVD-RAM
disk. The following table shows the approximate recording time (in minute)
for each side according the [FS/24] and [REC TR] switch settings.
Selecting an input source
Set the [INPUT MODE] switch appropriately according to the source
(microphone or line) connected to the [ANALOG MIC/LINE IN] connector.
For a line level analog
audio signal
F o r a d y n a m i c
microphone
F o r a c o n d e n s e r
m i c r o p h o n e w h i c h
requires the DC 48 V
phantom power.
F o r a c o n d e n s e r
microphone swhich
requires the DC 12 V
phantom power.
On channels 2, 4 and 6, the [PHASE] switches are provided, allowing reversing
the phase.