Fostex PD-6 - Manual (Page 22)

20
PD-6 DVD Location Recorder (Chapter 2: Before using the PD-6)
[DC IN] connector
AC adaptor
AD-15C
About AC adaptor
The optional genuine AC adaptor AD-15C is available. (Contact our dealer or
sale office for purchasing the AD-15C.)
Use only the AD-15C for an AC adaptor. Using another AC adaptor may damage
the PD-6 due to the mismatch of the power voltage, polarity, etc. When connect or
disconnect the AC adaptor, make sure that the [POWER] switch is set to “OFF”.
• Connecting the AC adaptor
While the [POWER] switch of the PD-6 is set to “OFF”, insert the XLR-4-32 type connector
of the AD-15C to the [DC IN] connector on the right side panel of the PD-6 until it is
locked. Then connect the AC plug to the AC main outlet.
When using an external power supply such as the AC adaptor, set the [POWER
SEL] switch under the [DC IN] connector to the “EXT” position.
While operating the PD-6 with an external power supply (AC adaptor or external
battery), you can change the AC main outlet connected to the adaptor or replace
the external power supply without TC interruption if the fully charged NP-1 type
is installed to the PD-6. See below for the procedure.
1) Make sure that the fully charged battery is installed to the PD-6.
2) Set the [POWER SEL] switch to “INT” from “EXT”.
3) Change the AC main outlet connected to the adaptor or replace the external
power supply.
4) Set the [POWER SEL] switch to “EXT” from “INT”.