FUJITSU M3099EX/EH - Manual (Page 79)

M3099EX/EH OEM Manual 3-51
INTERFACE
SPECIFICATIONS
START command
When the scanner receives this command, this scanner reports the
size of document being read.
Byte 1
CNT
X'02'
Byte 2
CMD
X'53'
Byte 3
or␣ later
—
READ command
When the scanner receives this command, the scanner starts reading
based on the proviously set operation mode.
Issuing the response other than Read Complete during read
operation causes error.
Byte 1
CNT
X'02'
Byte 2
CMD
X'54'
Byte 3
or␣ later
—
SENSE command
When the scanner receives this command, the scanner reports the
scanner status. The sense command can be issued at any time if
another command does not require the response from the scanner.
Byte 1
CNT
X'02'
Byte 2
CMD
X'41'
Byte 3
or␣ later
—