FUJITSU M3099EX/EH - Manual (Page 152)

4-22 M3099EX/EH OEM Manual
[Start]/[Stop] button
Reading is started or stopped using the Start and Stop buttons as
follows:
[Start] button
Read operation can be started in either manual or automatic start
mode. To start reading in manual start mode, press this button
while the ready indicator is lit. (*1)
*1: Make sure that the LCD is initial screen of simplex or duplex
reading mode. If not press Stop button once, then press Start
button.
Manual start mode: Reading is started by the Start button.
Automatic start mode: Reading is started by a command from the
host machine.
[Stop] button
This button is effective regardless of whether the scanner is in
manual or automatic mode. Press this button to stop the read
operation.
During reading: Reading immediately stops and the document
being fed are ejected to the stacker.
The hopper table is lowered to the bottom.
Before reading: A prepicked document if any is ejected to the
stacker. The button works only when a document
is picked.
The hopper table is lowered to he bottom.
Note: If a document which is not picked remain in front of ADF.
Please set the document on the hopper again.