FUJITSU M3099EX/EH - Manual (Page 199)

M3099EX/EH OEM Manual A-3
ENDORSER
6 If you want to return to the ENDORSER INITIAL
screen (Screen 2), press [Mode 1] and [Mode 2] at a
time.
7 If you want to return to the initial status to read, press
[STOP].
A2.3 How to set the print number reset condition
You can choose whether to reset or not when HOPPER EMPTY is detected.
8 At Screen 1 press [Mode 1] nine times to go to the
ENDORSER RESET METHOD screen. (Screen 7)
9 Press [Mode 2] to see Screen 8. If “ON” is displayed,
the print number will be reset when HOPPER
EMPTY is detected. If “OFF” is displayed, it
wouldn’t. The “ON” or “OFF” status flips each time
you press [Mode 1]. The status will be set in
EEPROM automatically.
10 If you want to return to Screen 7, press [Mode 2].
If you want to close the job, go to 7 .
A2.4 How to reset the print number manually
You can reset the print number to the initial number by operator panel as follows.
11 At Screen 1 press [Mode 1] ten times to go to the
ENDORSER RESET screen. (Screen 9)
12 Press [Mode 2] to see Screen 10. You may see current
print number. If you want to reset the number, press
[Mode 2]. And you can see Screen 11 for 3 sec. If you
don’t want it, press [Mode 1] to go to Screen 9.
If you want to close the job, go to 7 .
EEPROM Writing!!
Screen 6
<< SETUP MODE >>
ENDORSER RESET METHOD
Screen 7
HOP-EMPTY RESET
ON
Screen 8
<< SETUP MODE >>
ENDORSER RESET
Screen 9
RESET VALUE 0 0 0 0 1
No-Mode 1 Yes-Mode 2
Screen 10
RESET Finish !! 0 0 0 0 1
Screen 11