FARGO electronic FARGO DTC 400 - Manual (Page 94)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.6) 4-37
Flipper Table Module Assembly Problems
Resolving the No Flipper Table Module problem
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer. See the
Flipper Table Module Installation section (as needed).
Step Procedure
1 Review the following information.
• Symptom: The Flipper Table Module Assembly is not functioning.
• Printer Error State: The Printer is unable to communicate with the Flipper
Module.
• LCD Error Display: No Flip Installed
• Driver Monitor Error Display: No Flipper Module