FARGO electronic FARGO DTC 400 - Manual (Page 4)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.6) iv
Print Process Errors __________________________________________________________________ 4-5
Resolving a Card Not Fed Error (Cards will not feed off the Hopper)_________________________ 4-5
Resolving a Card Not Fed Error (Two (2) or more card feed at the same time)__________________ 4-8
Resolving a Ribbon RFID Error (Ribbon RFID Antenna is Corrupted)_______________________ 4-10
Resolving a Ribbon RFID Error (Ribbon RFID Sensor is Corrupted) ________________________ 4-12
Resolving the Mag Verify Error _____________________________________________________ 4-13
Resolving the No Mag Installed Error ________________________________________________ 4-16
Resolving a Ribbon Sensor Error (Ribbon Miscue) ______________________________________ 4-18
Resolving a Ribbon Break Jam Error _________________________________________________ 4-20
Resolving a Ribbon Out Error ______________________________________________________ 4-22
Resolving a No Ribbon Installed Error________________________________________________ 4-23
Resolving a Invalid Ribbon Error____________________________________________________ 4-25
Resolving a Wrong Ribbon Error ____________________________________________________ 4-27
Resolving a Card Jam Error ________________________________________________________ 4-29
Resolving a Headlift Motor or Sensor Error____________________________________________ 4-31
Resolving the Cover Open Error Message _____________________________________________ 4-33
Resolving the Blank Output issues ___________________________________________________ 4-34
Flipper Table Module Assembly Problems _______________________________________________ 4-37
Resolving the No Flipper Table Module problem _______________________________________ 4-37
Resolving the Flipper Jam Error_____________________________________________________ 4-38
Diagnosing Image Problems __________________________________________________________ 4-40
Resolving the Pixel Failure problems _________________________________________________ 4-40
Resolving the Card Surface Debris problems ___________________________________________ 4-41
Resolving the Incorrect Image Darkness problems ______________________________________ 4-42
Resolving Ribbon Wrinkle problems _________________________________________________ 4-44
Resolving the Excessive Resin Printing problems _______________________________________ 4-46
Resolving the Incomplete Resin printing problems ______________________________________ 4-48
Resolving the Image Placement problems _____________________________________________ 4-49
Resolving the Poor Image Quality problems ___________________________________________ 4-52
Running the Self Test _______________________________________________________________ 4-53
Running the Standard Self Test Print _________________________________________________ 4-53
Running the Magnetic Self Test (HiCo Only) __________________________________________ 4-54
Section 5: Ethernet Option __________________________________________________ 5-1
Introduction __________________________________________________________________5-1
Technical Specification - Ethernet Option ________________________________________________ 5-1
Functional Specification - Ethernet Option ________________________________________________ 5-2
Network Services - Overview __________________________________________________________ 5-3
Reviewing the Print Server__________________________________________________________ 5-3
Reviewing the Web Page Server _____________________________________________________ 5-3
Reviewing the Network Management Interface __________________________________________ 5-3
Reviewing the Telnet Server ________________________________________________________ 5-3
Network Management Interface ________________________________________________________ 5-4
Telnet Command Line Interface ________________________________________________________ 5-4
Initiating a Telnet Session __________________________________________________________ 5-4
Reviewing the Telnet Command Table ________________________________________________ 5-5
Ethernet Web Pages – Standard Procedures ______________________________________5-11
Reviewing Web page security _________________________________________________________ 5-11
Logging In ________________________________________________________________________ 5-12
Accessing the Home page ____________________________________________________________ 5-13
Reviewing the Home Page ___________________________________________________________ 5-14
Reviewing the Home Page Categories and Fields (table)__________________________________ 5-15
Configuring the Network Settings______________________________________________________ 5-16
Accessing the Network Settings page_________________________________________________ 5-16
Reviewing the Interface ___________________________________________________________ 5-17