Using the print path page – FARGO electronic FARGO DTC 400 User Manual
Page 134
![background image](/manuals/103767/134/background.png)
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.6)
5-23
Using the Print Path page
The purpose of the Print Path page is to allow the User to view or change the TCP port
numbers used to communicate to the printer. If these settings are left to the default entry of
0 then the default ports of 9100, 5400 and 5402 will be used for the RawSocket TCP Port,
the CPS Data TCP Port and the CPS Command TCP Port respectively. The CPS
Command TCP Port is dependent on the setting of the CPS Data TCP Port and always two
units higher.
Step Procedure
1 Select
the
Print Path link.
2
View the active configuration of the printer in the Current Settings area on
this page.
3
New port numbers may be entered into the Stored Settings area in the
text boxes provided on this page.