Network management interface, Telnet command line interface, Initiating a telnet session – FARGO electronic FARGO DTC 400 User Manual
Page 115: Network management interface -4, Telnet command line interface -4, Initiating a telnet session -4
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.6)
5-4
Network Management Interface
The SNMP interface is described below.
Interface Description
SNMP
• The Ethernet interface is a fully-manageable SNMP agent that supports
MIB-II.
• The Ethernet interface is MIB II compliant, allowing SNMP managers to
monitor protocol, network and routing statistics.
Telnet Command Line Interface
Initiating a Telnet Session
This procedure shows how to initiate a Telnet session from a PC in order to access the
Telnet services provided by the Printer. Follow these instructions to issue Telnet commands.
Step Description
1
Identify the IP address of your Printer. (Note: See the
2
Initiate a Telnet session from a DOS window on your PC. At the DOS prompt,
enter telnet [IP Address]
Example: C:\>telenet 192.168.11.12
• All Telnet responses from the Printer will then be displayed in the
Telnet session on the PC.
• All commands entered will be sent to the Telnet client in the Printer.
3
Enter help or ? to get an on-window list of supported Telnet commands.