Resolving a headlift motor or sensor error, Resolving a headlift motor or sensor error -31, Resolving the headlift motor – FARGO electronic FARGO DTC 400 User Manual
Page 88: Sensor error
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.6)
4-31
Resolving a Headlift Motor or Sensor Error
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1
Review the following information.
• Symptom: The Printhead continuously cycles or does not cycle at all
• Printer Error State: Headlift Sensor is not detecting movement from the
Headlift Cam
• LCD Error Display: Head Lift Error
• Driver Monitor Error Display: General Error