Switching to the automatic ip address mode, Switching to the automatic ip address mode -18 – FARGO electronic FARGO DTC 400 User Manual
Page 129
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.6)
5-18
Switching to the automatic IP address mode
Step Procedure
1 Select
the
Network link from any web page of the Printer.
2 Select
the
Obtain an IP address automatically radio button to enable the
DHCP/BOOTP, which automatically assigns the network settings.
Even with this button selected, the User can enter Stored Settings, and the
Stored Settings will remain in memory. See below. (Note: This is the
default method.)
3
Click on the Submit button to save this setting.
4
Log in as a root User if you are so prompted. (Note: Any change of setting
will only be accepted after you have successfully logged in.)
5
Reboot the Printer to affect this change. See the procedures in
.