Fortinet FortiGate 100 - Manual (Page 179)

Users and authentication Adding user groups
FortiGate-100 Installation and Configuration Guide
179
Configuring user groups
To enable authentication, you must add user names, RADIUS servers and LDAP
servers to one or more user groups. You can then select a user group when you
require authentication. You can select a user group to configure authentication for:
• Policies that require authentication. Only users in the selected user group or that
can authenticate with the RADIUS servers added to the user group can
authenticate with these policies.
• IPSec VPN Phase 1 configurations for dialup users. Only users in the selected
user group can authenticate to use the VPN tunnel.
• XAuth for IPSec VPN Phase 1 configurations. Only users in the selected user
group can be authenticated using XAuth.
• The FortiGate PPTP configuration. Only users in the selected user group can use
PPTP.
• The FortiGate L2TP configuration. Only users in the selected user group can use
L2TP.
When you add user names, RADIUS servers, and LDAP servers to a user group the
order in which they are added affects the order in which the FortiGate unit checks for
authentication. If user names are first, then the FortiGate unit checks for a match with
these local users. If a match is not found, the FortiGate unit checks the RADIUS or
LDAP server. If a RADIUS or LDAP server is added first, the FortiGate unit checks the
server and then the local users.
If the user group contains users, RADIUS servers, and LDAP servers, the FortiGate
unit checks them in the order in which they have been added to the user group.
This section describes:
• Adding user groups
• Deleting user groups
Adding user groups
Use the following procedure to add user groups to the FortiGate configuration. You
can add user names, RADIUS servers, and LDAP servers to user groups.
To add a user group:
1 Go to User > User Group.
2 Select New to add a new user group.