Enabling and disabling policies, Disabling a policy, Enabling a policy – Fortinet FortiGate 100 User Manual
Page 150: Addresses
150
Fortinet Inc.
Enabling and disabling policies
Firewall configuration
4
Type a number in the Move to field to specify where in the policy list to move the policy
and select OK.
Enabling and disabling policies
You can enable and disable policies in the policy list to control whether the policy is
active or not. The FortiGate unit matches enabled policies but does not match
disabled policies.
Disabling a policy
Disable a policy to temporarily prevent the firewall from selecting the policy. Disabling
a policy does not stop active communications sessions that have been allowed by the
policy. To stop active communication sessions, see
1
Go to Firewall > Policy.
2
Select the policy list containing the policy to disable.
3
Clear the check box of the policy to disable.
Enabling a policy
Enable a policy that has been disabled so that the firewall can match connections with
the policy.
1
Go to Firewall > Policy.
2
Select the policy list containing the policy to enable.
3
Select the check box of the policy to enable.
Addresses
All policies require source and destination addresses. To add addresses to a policy
between two interfaces, you must first add addresses to the address list for each
interface.
You can add, edit, and delete all firewall addresses as required. You can also organize
related addresses into address groups to simplify policy creation.
A firewall address consists of an IP address and a netmask. This information can
represent:
• The address of a subnet (for example, for a class C subnet,
IP address: 192.168.20.0 and Netmask: 255.255.255.0).
• A single IP address (for example, IP Address: 192.168.20.1 and
Netmask: 255.255.255.255)
• All possible IP addresses (represented by IP Address: 0.0.0.0 and Netmask:
0.0.0.0)
NO
Note: IP address: 0.0.0.0 and Netmask: 255.255.255.255 is not a valid firewall address.