FUJITSU M304X - Manual (Page 98)

(2) Select Vertical Pitch command
The Select Vertical Pitch command specifies the printer line feed pitch (6
or 8 lpi).
When 6 lpi is specified, the parameter is 31 32 30, as follows:
5B
o r 3 1 3 2 2 0 4 7
9 B
When 8 lpi is specified, the parameter is 39 30, as follows:
5B
o r 39 30 20 47
9 B
Parameter
If the parameter has a value other than the value it is regarded as
an invalid control sequence and the specified is not performed.
(3) Set to Initial State command
The Set to Initial State command returns the FCB contents to the
set value, clears the horizontal control buffer in which the
horizontal tab stop data is loaded, returns the printer line feed pitch to
that specified by the setting, and inhibits the printer from translating
data codes when the printer receives the SO code.
H o w e v e r , an error caused by the printer, for example, hammer check or band
speed check, is not cleared.
(4) Skip to Channel-n
The skip to Channel-n command directs the printer to feed forms up to the
line corresponding to the channel specified in the data after data
received before this command is printed. The channel number is specified
by the parameter as follows:
-Channel 7
-Channel 2 Channel 8
-Channel 3 Channel 9
-Channel 4 30' Channel 10
-Channel 5 31' Channel 11
-Channel 6 32' Channel 12
This control sequence is regarded as invalid under following
conditions:
. The specified in this is not present in the FCB
even though the FCB is loaded.
. This command is specified even though the FCB is not loaded. If channel
is specified, however, the printer prints data and feeds
forms up to the TOF line.
6 23