FUJITSU M304X - Manual (Page 57)

WIF8 is ignored in mode. WIF5 must be 0 because WIF5 indicate Space
commands.
If no channels are specified in the FCB, the printer detects an error and
only prints, it does not feed forms. Because commands X'OC' to
specify invalid channels, the printer detects then as errors.
(2) Space commands
commands feed forms the specified number of lines after printing.
If data to WIF8 sent with the Paper Instruction signal is the same as
the that shown in Tables 4.6 and 4.7, the printer microprogram)
determines that the data indicates a Space command. The relationship
between Space command data and the number of lines fed is shown in Tables
4.6 feed mode) and 4.7 feed mode).
Table 4.6 Space commands feed mode)
WIF data
No. of lines fed
x x x 1 0 0 0 0 10 0
11
x x x 1 0 0 1 0 1 2 2
13 3
i
X X X 1 1 1 1 0 14
15
Table 4.7 Space commands feed mode)
WIF data
8 7 6 5 4 3 2 1 ~
No. of lines fed
x 0 0 1 0 0 0 0 1 0 0
1 1 1
x 0 0 1 0 0 1 0 1 2
.
2
15
x 0 1 1 0 0 0 0 30 16
x 0 1 1 0 0 0 1 31 17
.
3F 31
x 1 0 1 0 0 0 0 50 32
51 33
X l 1 1 1 1 1 0 7 E
X l 1 1 1 1 1 1 7 F
63
4 21