FUJITSU M304X User Manual

Page 58

commands are used in the following modes:

feed mode

A maximum of 15 lines can be fed.

WIF6 to

are ignored.

. 63-line feed mode

A maximum of 63 lines can be fed.

WIF7, WIF6, and WIF4 to

indicate

the number of lines fed.

WIF8 is ignored.

One of these modes can be selected at the operator panel.

For the

selection method, refer

to Operator’s

Guide.

When the printer receives a Space command, the printer feeds forms the

specified number of lines after printing all characters in the PDB. If
the Space command is received before the

(or

character code,

the remaining characters are treated as spaces.

If the Space command is

received without character codes,. the printer does not print, it only
feeds forms.

WIF5 must be 1 because

indicates Space commands.

If a Space command

to feed forms past the TOF position, the forms

feed can be stopped at the TOF position. This feature is called the
"step-count truncate".

This feature can also be set up at the operator

panel.

For the setting method, refer to

Operator’s