FUJITSU M304X - Manual (Page 76)

5.5.2 Skip to Channel-n commands
When one of the data items shown in Table 5.4 follows the FCB command control
code issued after print data, the printer determines that
data is the Skip
to Channel-n command. The printer prints all the data in the PDB and advances
the form to the line corresponding to the specified channel position in the FCB
data.
Table 5.4 shows the relationships between the Skip to channel-n command data
and channel numbers.
Table 5.4 Skip to Channel-n commands
Data Bit signal
8 1 6 5 4 3 2 1
Number of lines fed
x x x 0 0 0 0 1 0 1 C h a n n e l 1
x x x 0 0 0 1 0 0 2 Channel 2
x x x 0 0 0 1 1 0 3 Channel 3
x x x 0 0 1 0 0 0 4 Channel 4
x x x 0 0 1 0 1 0 5 Channel 5
I
x x x 0 0 1 1 0 0 6 Channel 6
x x x 0 0 1 1 1 0 7 Channel 7
x x x 0 1 0 0 0 Channel 8
x x x 0 1 0 0 1 0 9 Channel 9
I
x x x 0 1 0 1 0 O A Channel 10
x x x 0 1 0 1 1 O B Channel 11
x x x 0 1 1 0 0 oc Channel 12
x x x 0 1 1 0 1 O D Undefined
An error
x x x 0 1 1 1 1
If an undefined command or a channel No. no loaded in the FCB is specified, the
printer enters the fault state and displays error information on its STATUS
indicator.
5 18