FUJITSU M304X - Manual (Page 104)

Table 6.6 Printer status continued
code
2 9
3 0
3 1
43
44
45
49
50
3 5
3 6
3 9
40
41
Printer status
NOCHNL
(Channel selected,
FCB Not
loaded)
NOCHNL
(Illegal channel)
(Illegal channel)
Invalid character
code
FUSE
(Fuse 3 and
fuse
FUSE
(Fuse
Form length mode
FCB mode
load FCB mode
. The line feed pitch was designated as 6 lpi Status
lines per inch by printer setting.
6 lines per inch
lines per inch
Auto-perforation
skip enabled
tab Sel.
channel 3
Vert. tab
channel 4
Description
printer tried to execute the Skip 'to Channel
command, but FCB was not loaded.
printer tried to execute the Skip Channel
command, but the specified channel number was not 1
12.
specified channel number in the load FCB Error
data was not 1 to 12. The printer regards it as an
error.
An invalid character code occurred. printer
does not regard it as an error and doe:; not stop.
It is converted into
status
The forms feed fuse The regards
it as a" error and stops.
The hammer drive fuse was The printer
regards it as an error and stops.
. printer is in this status before
Data command is issued from the host,, or before
FCB image data is loaded by the
. The printer received load FCB data and
the data in the FCB in the printer.
. The printer is put in this status when the
FCB data is correct. If not, the code is
39.
. FCB data loaded by and written
in FCB.
. If the data is not correct, the status data is 39.
. correctly receiving the Vertical Pitch
from the host, the printer is put in the
lpi status that the host designates. At that
time, the printer does not transmit this status
code to the host.
printer is in 6 lpi mode.
The printer is in lpi mode.
perforation skip function is enabled
VT = channel 3
VT = channel 4
6 29