FUJITSU M304X - Manual (Page 18)

Table 2.4 conditions
Ambient
condi-
tions
M 3 0 4 0 M 3 0 4 1
t o t o
20% to 80%
when Temperature range t o t o
o p e -
Temperature gradient below
rating Relative 10% to (Without condensation)
Maximum wet-bulb
I temperature
Heat dissipation set
printing)
3 6 0
5 3 0
I I I
Air flow 5 7 I
2.4 Optional Unit
This section gives specifications of printer optional units such as the powered
stacker, long-line interface unit, format control tape line counter,
and paper puller.
Powered stacker
The powered stacker enables folding and stacking of forms.
Table 2.5
lists the powered stacker specifications. Figure 2.3 and 2.4 show the
outer dimensions, and the operation and maintenance areas for printers
with the powered stacker attached.
Table 2.5 Powered stacker specifications
Item I S p e c i f i c a t i o n s
Width
7 6 . 2
t o
4 3 1 . 8
mm
available Length 1 7 7 . 8
c o
3 5 5 . 6
for No. 1 to
5 . 6
for carbonless
Capacity 3000 part, 17 stacked 32 cm high
consumption
60
VA maximum (powered stacker only)
Dimensions
7 0 0
width 960 417 (16.42”) width
Weight Powered stacker only:
6 0 k g
M3040 to M3042 with powered attached: 200
M3043 with powered stacker attached: 220 kg (485
2 - 6