FUJITSU M304X User Manual

Page 93

(6) FF

code

The FF code directs the printer to feed

up to the line at the top of

on the next page.

control buffer (FCB; in this

it is also called

data

is loaded, the line on which channel 1 is specified is

line at the

TOF.

If the printer receives print data before

code, it prints

the data,

then feeds forms.

Then,

the horizontal print position is set to

column 1.

(7) CR

code

The CR code sets the horizontal print position in

If the

printer receives print data before receiving this code, it prints the
data,

then sets the horizontal print position to column 1.

If the Automatic New Line on CR Code function is set from the operator

panel,

the printer feeds one line in addition to performing the operation,

above.

(8) SO

code

The SO code translates character codes

into

X'FE'.

The SO code is valid if

mode is selected in setup DT BIT from the

operator panel.

the printer ignores this code, but does not

regard it as an invalid code.

When receiving the

code, the printer

stops data code translation.

When receiving an

code after an SI code or when receiving an SO code

after an SO code, the printer ignores the second SI or SO code and the
printer state does not change whether data codes are to be translated or

not.

(9) ESC

code

The ESC code indicates that the data following it is

sequence

in 7-bit mode.

For the control sequence, see Section 6.5.

6 18